New Holland CX720 Repair Manual page 2815

7. Run a chain or lifting strap through the wheel motor
C-frame. Use a hoist or lift to hold the wheel motor
once the C-frame has been unbolted.
Remove the four bolts (1) which secure the C-frame
to the axle beam. The wheel motor will be then be
free from the axle beam.
NOTE: The wheel motor is heavy and may move in the
C-frame when the lifting strap is disconnected and the hoist
no longer supports the weight of the wheel motor.
8. Lower the wheel motor and C-frame to the ground
with the flat portion of the C-frame resting on the
ground.
Attach two bolts into each side of the wheel motor
and connect a chain or lifting strap to the bolts. Sup-
port the wheel motor with a hoist or lift.
Remove the four bolts (1) which secure the bottom
pin to the C-frame. Remove the pin from the frame.
9. Remove the 5 bolts (1) which secure the top pin to
the C-frame. Remove the top pin from the C-frame.
Hydraulic fluid will drain from the motor.
TRAVELLING - 2WD-4WD SYSTEM Hydrostatic
2 4/7/2006
D.14.E / 61
3
20015305
4
20015307
5
20015308