New Holland CX720 Repair Manual page 2732

4. Remove all axle cap screws and nuts (1) holding the
extensions (2) into the center section. The hardware
is torqued to 470 - 490 N·m (347 - 361 ft. lbs.).
Use the appropriate lifting gear and remove the axle
extensions from the center section.
NOTE: The hub casting or powered rear axle elements do
not need to be removed, but appropriate lifting gear must
be used to support the weight.
5. Raise the combine as required and set jack stands
under the left and right sides of the main frame di-
rectly forward of the axle stops as shown. Lower the
combine frame carefully onto the jack stands.
NOTE: Raise and lower the combine evenly on both sides.
Because of the center pin axle mount, the combine will shift
toward the side that is lower. Failure to keep the combine
level may result in the unit falling off a jack stand and could
result in death or serious injury.
6. Remove the four cap screws and nuts (1) from the
hitch mount.
TRAVELLING - REAR AXLE
2 4/7/2006
D.12.A / 4
3
10010490
4
10010505
5
10010506