New Holland CX720 Repair Manual page 2753

TRAVELLING - REAR AXLE
5. While holding the assembly in position, set the inner
bearing (1) onto the spindle with the tapered side in.
Slide the washer (2) on behind the bearing and turn
on the castellated nut (3) Tighten the nut to draw the
seal into place, do not exceed 60 N·m (44 ft. lbs.).
Turn the nut off and remove the washer. Give the
spindle assembly a slight tug to ensure that the seal
is properly seated in the hub. If the seal comes out
of the hub easily, repeat this step until the assembly
will remain in place.
Remove the inner bearing from the spindle. Fill the
bearing cavity with a good quality wheel bearing
grease.
Set the inner bearing onto the spindle with the ta-
pered side in. Slide the washer on behind the bear-
3
20013340_1000
ing and turn on the castellated nut. Tighten the nut to
60 N·m (44 ft. lbs.). Line up the nut with the cotter
pin hole in the spindle. If required, turn the nut in the
loosen direction.
Install the cotter pin. Tap on the dust cap.
Install the tires onto the combine noting the direction
of travel as marked on the tire. Torque the lug nut
to 406 - 435 N·m (300 - 321 ft. lbs.). Remove the
jack stands from under the combine and lower it to
the ground.
2 4/7/2006
D.12.A / 25