New Holland CX720 Repair Manual page 2721

26. Install the lock plate (8), without rotating the nut (9),
in such a way that 4 lips can be bended into the cams
of the nut (9).
Install the lock plate (7) and the bolts (6). Tighten the
bolts (6) to 45 - 55 Nm. Bend 2 lips per bolt after
assembly. Remove the by bending created burrs.
NOTE: The lock plate (8) has 5 installation positions on
each side (5 x 2 = 10 position) and is designed in such a
way that always 4 lips can be bend into the cams of the nut
(9) no matter the position of the nut.
NOTE: Install the lock plate (7) with its bend to the middle
as shown, otherwise interference with the cover (5) can
occur.
27. Apply sealing compound type 6 (Loctite 638) to the
cover (5) and install the cover.
28. Apply sealing compound type 1 (Loctite 242) to the
threaded studs (1).
Install the threaded studs (1) and tighten them to a
torque of 15 - 25 Nm.
29. Apply sealing past (Loctite 5065) (S) between the
inner housing (10) and the outer housing (26) all
around.
TRAVELLING - FRONT AXLE
2 4/7/2006
D.10.A / 67
23
ZEIL05CX0518A0C
24
zda4665b
25
ZEIL05CX0534A0B
26
ZEIL05CX0535A0B