New Holland CX720 Repair Manual page 2739

Steering knuckle - Assemble (D.12.A.69 - F.10.A.20)
1. Using the locally fabricated tool, insert the bushing
(1) and press into place until there is a maximum of
3 mm (0.118 in) gap at the bottom of the bore. Apply
a generous coating of grease to the bushing and fill
the area above with the same grease. Install the seal
(2) with the cupped side up.
2. Using the locally fabricated tool, insert the bushing
(1) and press into place until there is a maximum of
3 mm (0.118 in) gap at the bottom of the bore. Apply
a generous coating of grease to the bushing and fill
the area above with the same grease. Install the seal
(2) with the cupped side up.
3. Inspect the machined ends (1) of the steering
knuckle for wear, scratches and gouges.
knuckle exhibits excessive play when assembled,
replace the knuckle.
TRAVELLING - REAR AXLE
If the
2 4/7/2006
D.12.A / 11
1
10010502_1001
2
10010501_1002
3
10010503