New Holland CX720 Repair Manual page 2748

23. Remove the two lifting bolts from each side of the
wheel motor and run the chain or lifting strap through
the top if the wheel motor C-frame. Use a hoist or lift
to hold the C-frame.
Position the wheel motor assembly up to the axle
beam. Be sure that the height of the wheel motor
is the same as the opposite side. Install the four
bolts (1) which secure the C-frame to the axle beam.
Torque the mounting bolts to 1255 N·m (925 ft. lbs.).
NOTE: The correct position of the wheel motor (s) can be
referenced by using the charts in Operators Manual.
24. Position the hydraulic lines up to the axle beam. Se-
cure the hydraulic lines to the axle using the hanger
(2) and hanger bolt (1).
25. Place the steering knuckle (2) up to the wheel motor
and install the four bolts (1) which secure the knuckle
to the motor. Torque the bolts to 435 N·m (320 ft.
lbs.).
Connect the hydraulic supply lines (3) and case drain
line (4) to the wheel motor. Make sure the hydraulic
supply lines are installed correctly or the motor will
not function properly.
Install the wheel/tire onto the wheel motor.
TRAVELLING - REAR AXLE
2 4/7/2006
D.12.A / 20
17
20015305
18
20015304
19
10010514_1019