Stylus Pro 5000
4.1.2 Tools
Use only the tools listed in Table 4-1.
Table 4-1. Required Tools
Name
Phillips screwdriver #1
Phillips screwdriver #2
Standard screwdriver
Cutting pliers
Thickness gauge set
Tweezers
Pliers (to remove C-ring from
shaft ST-0)
Pliers (to remove C-ring from
shaft ST-1)
Paper pick up detector adjust
tool
Positioning pin
Torque Wrench
4.1.3 Screws
Table 4-2 contains the screw abbreviations used in the disassembly
procedures.
Table 4-2. Screw Abbreviation
Abbreviation
CBS
CBP
CP
CB
Supplier
EPSON parts
code
EPSON
B743800400
EPSON
B743800200
EPSON
B74300100
Commercially
available
EPSON
B776702201
EPSON
B741000100
EPSON
103983900
EPSON
103984000
EPSON
103983200
Commercially
Use a 2-mm
available
diameter nail.
EPSON
B765106901
Name
Cross/Bind/S-tight screw
Cross/Bind/P-tight screw
Cross/Pan-head screw
Cross/Binding Screw
4.2 DISASSEMBLY
This section describes the disassembly procedures up to printer
mechanism removal and main board rear unit removal. The main board
rear unit can be removed without disassembling any other parts. Refer to
section 4.3 for printer mechanism disassembly procedures. Refer to
Figure 4-1 for items explained in this section.
Start
4.2.1
Upper Housing
Removal
4.2.2
Front Housing
Removal
4.2.3
Printer Mechanism
Removal
Figure 4-1. Disassembly Flowchart
Chapter 4 Assembly and Disassembly
4.2.4
Main Board Rear Unit
Removal
4-2