Home Position Sensor Removal; Paper Width And Encoder Pulse Sensor Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro 5000
5. Connect the paper end sensor lever B to the upper paper guide as
shown in Figure 4-66.
Torsion Spring
Paper End Sensor Lever B The spring should pass
Figure 4-66. Installing Paper End Sensor Lever B
6. Connect the rear frame to the upper paper guide, then reattach the 10
small screws and 9 torsion springs (189) you removed in step 1.

4.2.5.21 Home Position Sensor Removal

1. Remove the upper housing. (See section 4.2.1.)
2. Disconnect the sensor cable from the home position sensor.
3. Release the 2 hooks holding the home position sensor, then remove
the sensor from the mechanism. (See Figure 4-67.)
between these 2 tabs
Home Position
Sensor
Figure 4-67. Home Position Sensor Removal

4.2.5.22 Paper Width and Encoder Pulse Sensor Removal

1. Remove the upper housing. (See section 4.2.1.)
2. Remove the front housing. (See section 4.2.2.)
3. Remove the printer mechanism. (See section 4.2.3.)
4. Remove the printheads. (See section 4.2.5.3.)
5. Remove the carriage motor. (See section 4.2.5.8.)
6. Remove the carriage. (See section 4.2.5.10.)
Chapter 4 Assembly and Disassembly
Connector
Push 2 hooks in
the direction of
these arrows
4-33