Physical Specifications; Interfaces; Serial Interfaces - Epson Stylus Pro 5000 Service Manual

Stylus Pro 5000
Notes:
1. When the printer is not on, make sure that the printhead is capped.
2. When moving the printer, make sure that the printhead is capped and
the ink cartridges are installed.
3. If the printhead is not capped when the printer is off, turn the printer on.
The printer will automatically cap the printhead. Turn off the power after
capping the printhead.
4. Ink will freeze at 5
F (  15
C) but will be useable if left for 3 hours at a
temperature of 77
F (25
C).

PHYSICAL SPECIFICATIONS

Weight: 48.5 lb. (22 kg) (without paper trays, optional lower
cassette, or ink cartridges)
Dimensions: Body only:
25.2 in. (W) x 17.3 in. (D) x 8.82 in. (H)
[640 mm (W) x 439 mm (D) x 224 mm (H)]
With paper tray installed:
25.2 in. (W) x 27.7 in. (D) x 8.82 in. (H)
[640 mm (W) x 704 mm (D) x 224 mm (H)]
With optional lower paper cassette installed:
25.2 in. (W) x 23.0 in. (D) x 12.5 in. (H)
[640 mm (W) x 584 mm (D) x 318 mm (H)]

1.3 INTERFACES

The EPSON Stylus Pro 5000 is equipped with parallel and Macintosh
serial interfaces and a card slot for an optional type-B interface. This
section provides information on each interface.
SERIAL INTERFACE
Table 1-9. Serial Interface
Item
Transmission mode
Synchronization
Transfer speed
Data format
Handshaking
Adaptable connector
Recommended I/F cable
Chapter 1 Product Description
Description
Based on RS-423
Synchronous
About 1.8 Mbps
Start bit: 1 bit
Data bit: 8 bit
Parity bit: none
Stop bit: 1 bit
X-ON/X-Off, DTR protocol
8-pin mini circular connector
Apple system peripheral-8 cable
1-7