Epson Stylus Pro 5000 Service Manual page 104

Stylus Pro 5000
5. Loop the hopper timing belt around the hopper lock transmission gear,
and temporarily loop the other end around shaft A. (See Figure 4-91.)
CAUTION
The correct belt position is shown in Figure
4-91. The belt has been moved in other figures.
Hopper Timing Belt
Shaft "A"
Hopper Lock Transmission Gear
Figure 4-91. Hopper Timing Belt Installation
6. Install the lifter gear train cover, then place a bushing on the same
shaft as the hopper lock transmission gear. (See Figure 4-92.)
Lifter Gear Train Cover
Screws (CBS, 3×6)
Figure 4-92. Installing the Lifter Gear Train Cover
7. Secure the lifter gear train cover with 2 e-rings and 2 screws (CBS,
3×6). (See Figure 4-92.)
Chapter 4 Assembly and Disassembly
E-rings
Bushing
4-45