Paper Feed Frame Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro 5000

4.2.5.14 Paper Feed Frame Removal

1. Remove the upper housing. (See section 4.2.1.)
2. Remove the front housing. (See section 4.2.2.)
3. Remove the printer mechanism. (See section 4.2.3.)
4. Remove the printheads. (See section 4.2.5.3.)
5. Remove the carriage motor. (See section 4.2.5.8.)
6. Remove the carriage. (See section 4.2.5.10.)
7. Remove the paper eject frame. (See section 4.2.5.11.)
8. Remove the upper paper guide. (See section 4.2.5.12.)
9. Remove the pump frame. (See section 4.2.5.13.)
10. Remove 2 screws (CBS, 3×6) securing the paper feed frame to the left
frame, then remove the paper feed frame. (See Figure 4-50.)


REMINDER
 During assembly, insert the platen gap
driver shaft and the ink valve driver gear
into the corresponding holes in the right
frame, as shown in Figure 4-51.
 A bushing holds the ink valve driver gear
inside the left frame. During assembly,
insert the bushing tab into the hole on
the right frame shown in Figure 4-51.
Left Frame
Paper Feed Frame
Figure 4-50. Paper Feed Frame Removal
Platen Gap Driver Shaft
Figure 4-51. Paper Feed Frame Assembly
Chapter 4 Assembly and Disassembly
Screws (CBS, 3×6)
Ink Valve Driver Gear
Slot for bushing
tab
Tab
4-26