Calculating The Configuration Data - Festo FB16 Electronic Manual

VIFB16 - 03/05
Module type
Single-type valve sub-base (type 03)
Double-type valve sub-base (type 05)
ISO sub-base modules (type 05)
- 4 valve locations
- 8 valve locations
- 12 valve locations
4-output module (4 digital outputs)
4-input module (4 digital inputs)
8-input module (8 digital inputs)
Status bits **)
*) The I/Os are assigned automatically in the terminal, irrespective of whether
an input/output is actually used.
**) The status bits are assigned automatically in the terminal.
Fig. 4/1: Number of assigned I/Os per module
0506b
4. Commissioning

Calculating the configuration data

Before configuring, calculate the exact number of
available inputs/outputs. A modular valve termi-
nal consists of a varying number of I/Os,
depending on the type ordered.
PLEASE NOTE
•
The terminal provides four status bits for
diagnosis.
These are always assigned automatically
within the terminal, if at least one input
module is fitted.
•
The status bits occupy four input addresses.
The following table specifies the I/Os required
per module for the configuration.
Number of assigned I/Os*)
2 outputs
4 outputs
8 outputs
16 outputs
24 outputs
4 outputs
4 inputs
8 inputs
4 inputs
4-7