Festo Fieldbus; Configuration - Festo CP-FB5-E Manual

Cp fieldbus node 5

Hide thumbs Also See for CP-FB5-E:

Table of Contents

2. Commissioning

2.2

Festo fieldbus

Procedure

2-4

The field bus configurator in the FST software supports you in

creating the NOMINAL configuration. Menu control and oper-

ation of the FST software is described in the appropriate FST

manual.

1. Enter the field bus address of the field bus slave (CP

system).

2. Select the type of field bus slave ("Valve terminal 10" for

CP system).

3. Enter the number of assigned inputs/outputs in bytes

under IW/OW. The number of IW and OW must be the

same.

Please note

The entry mask for the field bus configurator shows IW and

OW on the screen. This means input and output words with

8 bits each. Enter 2 IW and 2 OW per string (16 inputs and

16 outputs).

Festo P.BE-CP-FB5-E-EN en 0112a

Table of Contents