Festo FB16 Electronic Manual page 48

VIFB16 - 03/05
3-6
3. Installation
2. Open the strain relief on the rear part of the
housing. Pass the cable through as shown in
the diagram below (PG = Conduit thread).
Cable diameter:
PG 7:
PG 9:
PG 13.5:
Plugs/sockets (straight/angled):
Power supply socket: PG 7, 9 or 13.5
Sensor plug:
Bus cable socket:
Socket
Fig. 3/1: Individual plug/socket parts and
cable routing
3. Remove 5 mm of insulation from the end of
the cable.
4. Fit the strands with cable end sleeves.
5. Connnect the ends of the cables.
6. Insert the connection part onto the housing
of the plug/socket again. Pull the cable back
so that it is not looped inside the housing.
7. Tighten the strain relief.
4.0 ... 6.0 mm
6.0 ... 8.0 mm
10.0 ...12.0 mm
PG 7
PG 7, 9 or 13.5
Cable
Strain relief
Housing
Connection
part
Plug
0506b