Installation Under Xtel (From V52); Versions Of Software Required - Festo FB16 Electronic Manual

VIFB16 - 03/05

4.2.2 Installation under XTEL (from V52)

4-22
4. Commissioning

Versions of software required

The configuration, programming and diagnosis of
Festo valve terminals with FB16 is possible with
the following versions using the XTEL-CONF
software package:
•
XTEL V52, if the diskette "Catalog TXT R
CTG V52" has been installed (the diskette
contains the requisite device reference/basic
device FSD_C8).
•
XTEL from Version 53 (contains the device
reference / basic device FSD_C8 as stand-
ard).
•
XTEL V6 (and PL7-3 V6).
The processors of series 7, TSX model 40 (with
integrated FIPIO field bus module) support the
device reference FSD-C8 (and therewith the
valve terminal) only from processor version
V5.3/V5.5.
PLEASE NOTE
• The following examples are taken from the
XTEL V52 Software.
• The software package may contain modifi-
cations which may not be reflected in this
description. Additional and updated notes
can be found in your software manual.
0506b