Configuring The Valve Terminal - Festo FB16 Electronic Manual

VIFB16 - 03/05
0506b
3. Installation
•
Opening
Unscrew the 6 Philips screws in the cover
and carefully remove the cover by lifting
upwards. Do not damage the cable through
mechanical stress.
•
Closing
Replace the cover. Place the cables for the
operating voltage connection back into the
housing so that they are not clamped. Tighten
the Philips screws in the cover in diagonally
opposite sequence.

Configuring the valve terminal

There are four PC boards in the node. Board 2
contains two LEDs and two plugs for the cables.
Board 3 contains two LEDs and two switches for
setting the configuration.
The following settings should be made with the
node cover open:
•
Setting the field bus address
(connection point)
•
Setting "HOLD/STOP"
(error reaction of the outputs)
3-9