Ii-2-2-9 Details Page For Ipv6 - 6In4 Static Tunnel In Ethernet Wan - Draytek Vigor3910 Series User Manual

RIPng Protocol
Bridge Mode
After finished the above settings, click OK to save the settings.
I I - 2 - 2 - 9 D
I I - 2 - 2 - 9 D
This type allows you to setup 6in4 Static Tunnel for WAN interface.
Such mode allows the router to access IPv6 network through IPv4 network.
However, 6in4 offers a prefix outside of 2002::0/16. So, you can use a fixed endpoint rather
than anycast endpoint. The mode has more reliability.
Available settings are explained as follows:
Item
Vigor3910 Series User's Guide
system to execute for WAN detection. Always On means no
detection will be executed. The network connection will be
on always.


RIPng (RIP next generation) offers the same functions and
benefits as IPv4 RIP v2.
Enable Bridge Mode - If the function is enabled, the router
will work as a bridge modem.
Enable Firewall – It is available when Bridge Mode is
enabled. When both Bridge Mode and Firewall check boxes
are enabled, the settings configured (user profiles) under
User Management will be ignored. And all of the filter rules
defined and enabled in Firewall menu will be activated.
Bridge Subnet – Make a bridge between the selected LAN
subnet and such WAN interface.
e t a i l s P a g e f o r I P v 6
e t a i l s P a g e f o r I P v 6
Description
Ping IP/Hostname – If you choose Ping Detect as
detection mode, you have to type IP address in this field
for pinging.
TTL (Time to Live) –If you choose Ping Detect as
detection mode, you have to type TTL value.
6 i n 4 S t a t i c T u n n e
6 i n 4 S t a t i c T u n n e
–
–
l i n E t h e r n e t W A N
l i n E t h e r n e t W A N
53