Draytek Vigor3910 Series User Manual page 301

Enable SNMP Agent
Get Community
Set Community
Manager Host IP (IPv4)
Manager Host IP (IPv6)
Trap Community
Notification Host IP (IPv4)
Notification Host IP (IPv6)
Trap Timeout
Enable SNMPV3 Agent
USM User
Auth Algorithm
Auth Password
Privacy Algorithm
Vigor3910 Series User's Guide
Check to enable SNMP function. Then, enable SNMPV1
agent/SNMPV2C agent.
Enter the Get Community string. The default setting is
public. Devices that send requests to retrieve information
using get commands must pass the correct Get Community
string.
The maximum allowed length is 23 characters.
Enter the Set Community string. The default setting is
private. Devices that send requests to change settings using
set commands must pass the correct Set Community string.
The maximum length of the text is 23 characters.
Enter the IPv4 address of hosts that are allowed to issue
SNMP commands. If this field is left blank, any IPv4 LAN host
is allowed to issue SNMP commands.
Enter the IPv6 address of hosts that are allowed to issue
SNMP commands. If this field is left blank, any IPv6 LAN host
is allowed to issue SNMP commands.
Enter the Trap Community string. The default setting is
public. Devices that send unsolicited messages to the SNMP
console must pass the correct Trap Community string.
The maximum length of the text is 23 characters.
Enter the IPv4 address of hosts that are allowed to send
SNMP traps.
Enter the IPv6 address of hosts that are allowed to send
SNMP traps.
The default setting is 10 seconds.
Check it to enable SNMPV3.
USM means user-based security mode.
Enter the username to be used for authentication. The
maximum allowed length is 23 characters.
Choose one of the hashing methods to be used with the
authentication algorithm.
Enter a password for authentication. The maximum allowed
length is 23 characters.
Choose one of the methods listed below as the privacy
algorithm.
Choose an encryption method as the privacy algorithm.
291