Draytek Vigor3910 Series User Manual page 563

E x a m p l
E x a m p
> prn status ?
Interface: USB bus 2.0
Printer: READY
Connect speed: 0K bps
Status: (null)
Info: (null)
VR9 USB host : USB1: READY , USB2: READY
T e l n e t C o m m
T e l n e t C o m m
This command allows user to set general settings for QoS.
S y n t a x
S y n t a x
qos setup [-<command> <parameter> | ... ]
S S y y n n t t a a x x
Parameter
[<command>
<parameter>|...]
-h
-m <mode>
-i <bandwidth>
-o <bandwidth>
-r <index:ratio>
-u <mode>
-p <ratio>
-t <mode>
-V
-D
[...]
E x a m p l
E x a m p
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
Vigor3910 Series User's Guide
e
l e
a n d : q o s s e t u p
a n d : q o s s e t u p
D D e e s s c c r r i i p p t t i i o o n n
e
l e
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type it to display the usage of this command.
It means to define which traffic the QoS control settings will apply
to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
It means to set inbound bandwidth in kbps (Ethernet WAN only)
The available setting is from 1 to 100000.
It means to set outbound bandwidth in kbps (Ethernet WAN only).
The available setting is from 1 to 100000.
It means to set ratio for class index, in %.
It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
It means to enable bandwidth limit ratio for UDP.
It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
Show all the settings.
Set all to factory default (for all WANs).
It means that you can type in several commands in one line.
553