Draytek Vigor3910 Series User Manual page 625

-m <interface>
-s
-y
-c <1/0>
-I -[M|H|D] <interval>
-h <Subnet> [<Virtual IP>]
-d <Subnet>
E x a m p l
E x a m p
> ha set -h LAN1 192.168.1.5
% Enable Virtual IP on LAN1
% Set Virtual IP 192.168.1.5 OK!!
>
T e l n e t C o m m
T e l n e t C o m m
This command can be used to show the settings information about config sync and general
setup.
S y n t a x
S y n t a x
ha show –c
ha show –g
S y n t a x
S y n t a x
Parameter
-c
-g
E E x x a a m m p p l
> ha show -g
% High Availability
% Redundancy Method
% Group ID
Vigor3910 Series User's Guide
update DDNS automatically.
0: Disable.
Specify the management interface.
Interface: LAN1 ~ LAN8, DMZ.
It means to get the newest status of other router (except the local
router).
It means sync local config to other router. Primary can executes this
command. Secondary can not execute this commad.
Enable or disable the function of Config Sync.
1: Enable.
0: Disable.
Set the Config Sync Interval for HA. Minimum interval is 15 minutes.
-M: Minute. Setting range is 0/15/30/45. (e.g., ha set -I -M 30)
-H: Hour. Setting range is from 0 to 23. (e.g., ha set -I -H 12)
-D: Day. Setting range is from 0 to 30. (e.g., ha set -I -D 15)
Enable and set virtual IP to the subnet.
Subnet: LAN1 to LAN8, DMZ.
Virtual IP: The type format shall be "xxx.xxx.xxx.xxx". (e.g,
192.168.1.0)
For example, to enable a virtual IP to the sunet, simply type:
ha set –h LAN1 192.168.1.5
Disable a virtual IP to the subnet.
Subnet: LAN1 to LAN8, DMZ.
For example, to disable a virtual IP to the subnet, just type:
ha set –h LAN1
e
l e
a n d : h a s h o w
a n d : h a s h o w
D e s c r i p t i o n
D e s c r i p t i o n
Description
Show the settings of config sync.
Show the settings of general setup.
l e e
: Disable
: Active-Standby
: 1
615