Enable
Physical Mode / Type /
Port
Line Speed(Kbps)
DownLink/UpLink
Active Mode
Load Balance
Info
After finished the above settings, click OK to save the settings.
To configure WAN interface settings, click the WAN# link to open the following page.
Available settings are explained as follows:
Item
Enable
Display Name
Physical Mode
Physical Type
36
WAN configuration page.
Check the box to enable this WAN interface.
Display the physical mode, physical type, and LAN port of
this WAN interface.
Display the downstream and upstream rate of this WAN
interface.
Display whether this WAN interface is Active device or
backup device.
Backup (WAN#)- Display the backup WAN interface for this
WAN when it is disabled.
V means the function of load balance for such WAN interface
is enabled.
In default, each WAN port is enabled.
Description
Choose Yes to invoke the settings for this WAN interface.
Choose No to disable the settings for this WAN interface.
Type the description for such WAN interface.
Display the physical mode of such WAN interface.
You can change the physical type for WAN or choose Auto
Vigor3910 Series User's Guide
Need help?
Do you have a question about the Vigor3910 Series and is the answer not in the manual?