Xerox WorkCentre Pro 423 Service Manual page 92

WorkCentre Pro 423/428
Chain- Description
Link
016-786
Unable to write temporary
file onto HD by Scan to
Server
016-787
Job template syntax error in
Scan to Server (Redirector
detection): Invalid server IP
address
016-793
HD Full
050-101
Paper jam
1. Slide the upper right unit
of the main unit and remove
the jammed paper.
2. Close the unit.
050-102
1. Slide the upper right unit
of the main unit, handle
Lever 1 in the unit, and
remove the jammed paper.
2. Close the unit.
050-103
1. Slide the upper right unit
of the main unit and remove
the jammed paper
according to the label inside
DADF unit.
2. Close the unit.
050-104
1. Slide the upper right unit
of the main unit and remove
the jammed paper.
2. Close the unit.
1. Pull out Paper tray 1 and
remove the jammed paper.
2. Push in the tray.
050-105
1. Open the lower right
cover of the main unit and
remove the jammed paper.
2. Close the cover.
LCD display Job log Corrective Action
Error resolved Short of 1. Try again a little
(***-***) hard disk later because HDD
area may be temporarily
full of print jobs.
2. Format HDD.
3. Replace HDD.
Error resolved Invalid Check the attribute
(***-***) server IP (string
address RepositoryName) in
the job template file.
Error resolved Short of Not needed
(***-***) hard disk
area
2-60
03/02
Chain- Description
Link
050-106
1. Open the upper right unit
and lower right cover and
remove the jammed paper.
2. Close the unit and cover.
050-107
Adjust paper on the manual
feed tray.
050-108
1. Open the upper right unit
and lower right cover and
remove the jammed paper.
2. Close the unit.
Remove all paper from the
manual feed tray and load
again.
050-109
1. Slide the upper right unit
of the main unit, handle
Lever 1 in the unit, and
remove the jammed paper.
2. Close the unit.
Slide the Finisher to the
right.
3. Open Cover 3 of the
Finisher and remove the
jammed paper.
4. Close Cover 3.
Return the Finisher to the
original position.
050-110
Slide the Finisher to the
right.
1. Open Cover 3 of the
Finisher and remove the
jammed paper.
2. Close Cover 3.
Return the Finisher to the
original position.
CHAPTER 2 TROUBLESHOOTING
2.3 Level 2 Troubleshooting
LCD display Job log Corrective Action