G3 Port; Product Outline; Product Code; Installation Procedure - Xerox WorkCentre Pro 423 Service Manual

8.12 G3 Port

8.12.1

Product Outline

This kit adds a G3 port for the simultaneous processing of transmission and receiving.
- When installing this kit for the first time, prepare also the Option Box Kit (Product Code:
EL200111) for installation at the same time.
Ref. A machine with the ISDN/G4 kit does not require the Option Box Kit because the
Option Box is already mounted.
8.12.2

Product Code

G3 Port: EL200109 (FX)
: EL200139 (FXA)
: EL200141 (FXK)
: EL200140 (TFX)
Option Box Kit: EL200111 (FX)
: EL200144 (220V:FXA,FXK)
: EL200143 (110V:TFX)
8.12.3

Installation Procedure

1. Check the accessories. (Figure-1)
Additional G3 Port
1) G3M PWB ........................... 1
2) NCU-C PWB ....................... 1
3) Data Cable 2
..........................
4) Screw 4
..................................
Option Box Kit
(a) Option Box 1
.........................
(b) Lower Bracket 1
...................
(c) Upper Bracket ................... 1
(d) Screw 8
.................................
WorkCentre Pro 423/428
2. Turn the main unit power off.
On printer or Fax-equipped machines, ensure that outstanding jobs have cleared
before servicing or interrupting the power to the machine as follows:.
•
FAX equipped machines: Ensure that the "Job in Memory" indicator on the control
panel goes out. Press "Job Status:Stop" button and confirm that the job has cleared
from the "Current Jobs" folder.
•
Printer machines: Ensure that "Ready to print or fax" is indicated on the printer
control panel.
Switch off the machine and disconnect the power cord.
3. Remove the Screws (3) and the Rear Cover.
4. Remove the Screws (7) and the Electrical Cover.
5. Remove the Screws (2) and remove the Rear Cover from the Cabinet.
6. Install the Upper Bracket. (Figure-2)
03/02
8-29
(Figure-1) j0hn8032
WARNING
8.12 G3 Port
CHAPTER 8 ACCESSORIES