Xerox WorkCentre Pro 423 Service Manual page 327

• l Lead Edge ...... 6/93
Min Nominal
Set range 0 61
0mm 2mm
Changes 0.0423mm / 1Step
• l Trail Edge ...... 6/94
Min Nominal
Set range 0 94
-17.5mm 2mm
Changes 0.26mm / 1Step
• l Side Edge (Rear) ...... 6/92
Min Nominal
Set range 0 57
Changes 0.0423mm / 1Step
• l Side Edge (Front) ...... 6/91
Min Nominal
Set range 1 73
Changes 0.0423mm / 1Step
WorkCentre Pro 432/428
13. Finisher
Max
ADJ 13.6.1 Adjusting the Paddle Position
94
Ref. PL: PL13.6
4mm
Purpose Optimise the positional relationship between
the Paddle Guide and Gear.
Adjustment
Max
On printer or Fax-equipped machines, ensure that
175
outstanding jobs have cleared before servicing or
26mm
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the con
Press "Job Status:Stop" button and confirm that the
Max
job has cleared from the "Current Jobs" folder.
94
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
Max
Switch off the machine and disconnect the
94
power cord.
Procedure
1. Remove the Rear Cover. (PL13.17)
2. Remove the Finisher Top Cover. (PL13.8)
3. Remove the Paddle Gear. (PL13.6)
trol panel goes out.
WARNING
03/02
4-53 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
4. With the Exit Transport Guide up (initial state), align
the Paddle Guide (resin section) with the convex.
(Figure-1)
(Figure-1) j0hn4d51
5. In the status of Figure-1, position the Paddle Gear
until the Stopper catches the detent, and secure the
Gear at the black Holder projection (PL13.6).
(Figure-2)
(Figure-2) j0hn4d52
4.3 Adjustment