Xerox WorkCentre Pro 423 Service Manual page 302

WorkCentre Pro 423/428
Installation
Procedure
1. Affix the DADF Platen Cushion. (Figure-2)
1) Press the Platen Cushion gently in the direction
of the arrow.
2) Lower the DADF Assembly gently and press it
against the Platen Cushion.
(Figure-2) j0hn4a04
4-28
03/02
REP.10.2.1 DADF Feeder Assembly
Ref. PL PL10.2
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the DADF Assembly. (REP10.1.1)
2. Remove the following parts.
1) DADF Rear Cover(PL10.2)
2) DADF Front Cover(PL10.2)
3) DADF Document Tray(PL10.2)
3. Remove the DADF Feeder Assembly. (Figure-1)
1) Remove the Arm.
2) Remove the screws (6).
3) Remove the screw.
4) Remove the DADF Feeder Assembly.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
Installation
Procedure
1. Perform the removal steps in reverse order with the
following notes in mind.
Note
4.2 Disassembly and Assembly
(Figure-1) j0hn4a05
Insert the Arm securely into the Solenoid
Pin. (Figure-2)
(Figure-2) j0hn4a06