Xerox WorkCentre Pro 423 Service Manual page 280

WorkCentre Pro 423/428
REP 2.4.2 Exit Assembly
Ref. PL: PL2.4
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Pull out the R/H Unit.
2. If the machine has an MSI, remove the MSI.
(REP11.1.1)
3. Remove the R/H Lower Cover. (Figure-1)
1) Remove the screws (2).
2) Remove the Handle.
3) Remove the screws (2).
4) Remove the R/H Lower Cover.
(Figure-1)j0hn4204
4-6 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
03/02
4. Remove the Exit Assembly. (Figure-2)
1) Remove the screw.
2) Push in the Rear Upper Rail.
3) Loosen the screws (2).
4) Remove the screws (2).
5) Remove the Exit Assembly.
(Figure-2)j0hn4205
Installation
Procedure
1. Perform the removal steps in reverse order.
4.2 Disassembly and Assembly
REP 2.4.3 OCT Assembly
Ref. PL: PL2.4
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Pull out the R/H Unit.
2. If with an F/U Tray, remove the F/U Tray. (PL2.4)
3. If the machine has an MSI, remove the MSI.
(PL11.1)