Xerox WorkCentre Pro 423 Service Manual page 317

6. Remove the Exit Roller Assembly. (Figure-3)
1) Release the Hook and remove the Pulley.
2) Remove the Bearing.
3) Remove the Exit Roller Assembly.
(Figure-3) j0hn4d26
Installation
Procedure
1. Perform the removal steps in reverse order.
WorkCentre Pro 432/428
REP 13.14.2 In-Roller Assembly
Ref. PL PL13.14
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the Finisher Assembly. (REP13.1.1)
2. Remove the Feed Motor Belt. (REP13.5.2)
3. Remove the Front Cover. (PL13.17)
4. Remove the Lever. (Figure-1)
1) Remove the spring.
2) Remove the Lever.
(Figure-1) j0hn4d24
5. Remove the Bearing. (Figure-2)
03/02
4-43
1) Release the Hook and remove the Bearing.
2) Slide the Roller in the direction of the arrow.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
(Figure-2) j0hn4d27
4.2 Disassembly and Assembly