Xerox WorkCentre Pro 423 Service Manual page 286

WorkCentre Pro 423/428
Installation
Procedure
1. Wind the auxiliary Carriage Cable around the Pulley.
(Figures- 3, -4, and -5)
1) Put the ball of the Carriage Cable in the groove
of the Pulley.
2) Wind the Cable in the spring hook side one and
a half times.
3) Secure the Cable on the spring hook side to the
Frame with gummed tape.
4) Wind the Cable on the ball side twice.
5) Secure the pulley-wound cable with gummed
tape.
(Figure-3) j0hn4310
4-12 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
03/02
(Figure-4) j0hn4311
(Figure-5) j0hn4312
4.2 Disassembly and Assembly
Reference Indicate the number of windings about
the Front and Rear Carriage Cables.
(Figure-6)
(Figure-6) j0hn4313
2. Install the ball side of the Carriage Cable. (Figure-7)
1) Hook the Carriage Cable on the Left Pulley of
the Half Rate Carriage.
2) Hook the ball on the Frame notch.
(Figure-7) j0hn4314