Xerox WorkCentre Pro 423 Service Manual page 282

WorkCentre Pro 423/428
(Figure-1) j0hn4209
4. Remove the Registration Chute Assembly. (Figure-
4)
1) Remove the KL-Clip (2).
2) Remove the Registration Chute Assembly.
(Figure-4) j0hn4210
Installation
Procedure
1. Perform the removal steps in reverse order.
4-8
03/02
3. IIT
REP 3.1.1 Platen Glass
Ref. PL PL3.1
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Remove the Platen Glass. (Figure-1)
1) Remove the screws (2).
2) Remove the Plate.
3) Remove the Platen Glass.
(Figure-1) j0hn4301
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
Installation
Procedure
1. Perform the removal steps in reverse order with the
following notes in mind.
Note
4.2 Disassembly and Assembly
Install the Platen Glass while pressing in
the direction of Arrow A and the Plate while
pressing in the direction of Arrow B.
(Figure-2)
(Figure-2) j0hn4302