Xerox WorkCentre Pro 423 Service Manual page 307

7. Remove the Read 1/2 Roller. (Figure-5)
1) Remove the KL-clip (2).
2) Remove the Pulleys (2).
3) Remove the Bearings (2).
4) Remove the KL- lip and Bearing.
5) Remove the Pulley and Bearing.
6) Remove the Read 1/2 Roller.
(Figure-5) j0hn4a20
8. Remove the Bracket. (Figure-6)
1) Remove the E- lip.
2) Remove the KL- lip, Pulley, and E- lip.
3) Remove the KL- lip and Bearing.
4) Remove the spring.
5) Remove the screw.
6) Remove the Bracket.
WorkCentre Pro 432/428
(Figure-6) j0hn4a21
9. Remove the Holder. (Figure-7)
1) Remove the screws (2).
2) Release the Hooks (2).
3) Remove the Holder.
(Figure-7) j0hn4a22
03/02
4-33 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
10. Remove the Reg. Roller. (Figure-8)
1) Remove the KL- lip and Bearing.
2) Remove the Reg Roller.
(Figure-8) j0hn4a23
Installation
Procedure
1. Perform the removal steps in reverse order.
4.2 Disassembly and Assembly