Xerox WorkCentre Pro 423 Service Manual page 42

WorkCentre Pro 423/428
Status Status Description
Code
F4-36 JAM at Finisher TIMING SENSOR Paper
(4F4C) TIMING SNR remaining on
F4-41 JAM at Finisher EXIT SENSOR ON even
(4F4D) EXIT SNR after paper ejection
F4-42 JAM at Finisher EXIT SENSOR not ON
(4F4E) EXIT SNR within specified time
F4-46 JAM at Finisher Paper remaining on EXIT
(4F4F) EXIT SNR SENSOR
F7-1 FINISHER COMPILER PATH COVER
(4F71) Interlock Open (top) or COMPILER PATH
COVER (lower) is open
F7-2 FINISHER STAPLER COVER is open
(4F72) Interlock Open at COMPILER
F7-3 FINISHER COMPILER TOP COVER is
(4F73) Interlock Open open
F8-1 FINISHER FIN SHER Interlock is open
(4F81) Interlock Open
J1-2 No toner There is no toner.
(4B12)
J3-1 Drum/Cartridge Drum/Cartridge installation
(4B31) installation defect
defect
CRU life CRU End of life
J6-1
(4B61)
J8-1 CRUM Access ID number mismatch
(4B81) Error
J8-3 CRUM Access Data read/write error
(4B83) Error
2-10
03/02
Corrective Ref.
Action BSD
Remove paper. 12.6
Remove paper.
12.4,12
.7
Remove paper. 12.4,12
.7
Remove paper. 12.7
Close the COVER. 12.2
Close the Cover. 12.1
Close the Cover. 12.2
Close the Cover. 12.2
Replace Drum/ 9.2
Cartridge, then
POWER
OFF/ON
Extract and 9.1
insert
Drum/Cartridge
9.1
Replace Drum/
Cartridge, then
POWER
OFF/ON
Replace Drum/ 9.1
Cartridge, then
POWER
OFF/ON
Replace Drum/ 9.1
Cartridge, then
POWER
OFF/ON
Status Status Description
Code
J8-4 CRUM Access ACK not received more than
(4B84) Error five times
L6-1 No Related Key counter not present
(49A1) Product
CHAPTER 2 TROUBLESHOOTING
2.3 Level 2 Troubleshooting
Corrective Ref.
Action BSD
Replace Drum/ 9.1
Cartridge, then
POWER
OFF/ON
Set key counter. 3.2C