Xerox WorkCentre Pro 423 Service Manual page 305

3. Remove the DADF Feed/Nudger Roll Assembly.
(Figure-2)
1) Remove the KL-clip.
2) Remove the Bearing.
3) Remove the DADF Feed/Nudger Roll Assembly.
(Figure-2) j0hn4a11
4. Remove the DADF Feed Roll. (Figure-3)
1) Remove the KL-Clip (3).
2) Remove the E-Clip.
3) Remove the pins (3).
4) Extract the Shaft.
5) Remove the DADF Feed Roll.
WorkCentre Pro 432/428
(Figure-3) j0hn4a14
Installation
Procedure
1. Perform the removal steps in reverse order with the
following notes in mind.
Note Install the Feed Roll with the arrow mark
side to the front. (Figure-4)
(Figure-4) j0hn4a15
03/02
4-31 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
Note When installing the chute, insert the
projections (2) securely into the Top Cover
holes. (Figure-5)
(Figure-5) j0hn4a13
4.2 Disassembly and Assembly