Xerox WorkCentre Pro 423 Service Manual page 290

WorkCentre Pro 423/428
Installation
Note After peeling off the Platen Cushion,
remove the remaining tape cleanly from the
Platen Cushion.
Procedure
1. Install the Platen Cushion. (Figure-2)
1) Peel off the Seal.
2) Push the Platen Cushion gently in the direction
of the arrows.
3) Lower the Platen Cover gently and press it
against the Platen Cushion.
(Figure-2) j0hn4321
4-16
03/02
REP 3.6.1 Control Panel
Ref. PL PL3.6
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
CAUTION
Be careful not to damage parts by static electricity.
Electronic parts may be damaged by static electricity. Be
sure to wear a wristband when handling electronic parts. If
no wristband is available, touch the metal frame before work
to eliminate static electricity as far as possible.
Procedure
1. Remove the Control Panel. (Figure-1)
1) Remove the screws (4).
2) Move the control panel to the right a little and lift
up to release the Panel Hook from the Frame.
3) 2) Disconnect the connector.
4) 3) Remove the Control Panel.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
Installation
Procedure
1. Perform the removal steps in reverse order.
4.2 Disassembly and Assembly
(Figure-1) j0hn4322