- Adjustment
1) Enter C/E Mode.
2) Change the set value of Chain/Function code "21/82."
- Change rate : 0.0423mm/1Step
- Reducing the value causes image cutting..
17. Perform the DADF lead edge registration adjustment.
- Check
1) Load the A3 Chart from the kit on the DADF and make one copy.
2) Check that the difference between lead edge registrations on the copy and A3
Chart is ± 1.3 mm or less.
- Adjustment
1) Enter C/E Mode.
2) Change the set value of Chain/Function code "21/80."
- Change rate : 0.127mm/1Step
- Reducing the value causes image cutting..
WorkCentre Pro 423/428
03/02
8-55
8.21 Duplex Auto Document Feeder
CHAPTER 8 ACCESSORIES