Xerox WorkCentre Pro 423 Service Manual page 326

WorkCentre Pro 423/428
ADJ 7.2.1 IOT Lead Edge Registration
Purpose To align the copy image on the Drum to the
lead edge of the paper.
Check
1. Enter the C/E mode and enter the Chain/Function
Code, "23/12" to print out the built-in Test Pattern
[Grid pattern (4BIT)] onto Tray 1 using A3 size
paper.
2. (Figure-1) Check that the distance from the lead
edge of copy to the specific point is 2.0±0.3mm.
(Figure 1) j0hn4702
Adjustment
1. Enter the C/E mode.
2. Change the setup value of Chain/Function Codes
"20/1".
• l When the measured value is shorter: Decrease the
value.
• l When the measured value is longer: Increase the
value.
Min Nominal
Set range 102 112
Changes 0.26mm / 1Step
ADJ 7.2.2 IOT Side Registration
Purpose To align the copy image on the Drum to the
side edge of the paper.
Check
1. Enter the C/E mode and enter the Chain/Function
Code, "23/12" to print out the built-in Test Pattern
[Grid pattern (4BIT)] onto Tray 1 using A3 size
paper.
2. (Figure-1) Check that the distance from the side
edge of copy to the specific point is 2.0±0.3mm.
(Figure 1) j0hn4703
Adjustment
1. Enter the C/E mode.
2. Change the setup value of Chain/Function Codes
"6/80". The image is shifted to the front by
increasing the set value.
• l When the measured value is shorter: Increase the
value.
• l When the measured value is longer: Decrease the
value.
Max
142
Min
Set range 1
Changes
4-52 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
03/02
Nominal Max
50 99
0.0423mm / 1Step
4.3 Adjustment
ADJ 7.2.3 Edge Erase Amount Adjustment
Purpose To obtain appropriate distances for the both
side edges, the lead edge and the trail edge.
Inst.. Lead Edge and Side Registration should have
already been adjusted.
Inst.. Vertical and horizontal magnification ratios should
already be adjusted.
Check
1. Make a solid black copy with the Platen Cover open
without placing any document.
3. Ensure that the white areas at the lead edge, the
trail edge, the side edge (rear) and the side edge
(front) are 2±1mm.
Adjustment
1. Enter the C/E mode.
4. Change set values for the following Chain/Function
Codes. (By increasing set values, erase amounts
will be increased.)