Xerox WorkCentre Pro 423 Service Manual page 278

WorkCentre Pro 423/428
11. Remove the Main Motor Assembly. (Figure-5)
1) Disconnect the connector.
2) Remove the KL-Clip.
3) Remove the Gear.
4) Remove the screws (4).
5) Remove the Main Motor Assembly.
(Figure-5) j0hn4104
4-4 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
03/02
Installation
Procedure
1. Perform the removal steps in reverse order with the
following notes in mind.
Note Install the Main Drive Assembly while lifting
the Link Assembly for CRU. (Figure-6)
(Figure-6) j0hn4105
4.2 Disassembly and Assembly
2. Paper Transport
REP 2.2.2 Size Cam
Ref. PL: PL2.2
Installation
Procedure
1. Slide the End Guide to the position of 8.5" to align
the Sector hole with the Tray hole. (Figure-1)
End Guide
(Figure-1) j0hn4201