Xerox WorkCentre Pro 423 Service Manual page 301

(Figure-1) j0hn4a01
Removal
Perform the installation steps in reverse order.
WorkCentre Pro 432/428
REP 10.1.2 DADF Platen Glass
Ref. PL PL10.1
Installation
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
Procedure
1. Install the DADF Platen Glass. (Figure-1)
1) Loosen the Screws (2).
2) Press the Platen Glass in the arrow A direction.
3) Press the DADF Platen Glass in the arrow B
direction.
4) Tighten the screws (2).
(Figure-1) j0hn4a02
2. Return the machine to the original position.
03/02
4-27
REP 10.1.3 DADF Platen Cushion
Ref. PL PL10.1
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
Switch off the machine and disconnect the
power cord.
Note
Procedure
1. Peel off the DADF Platen Cushion. (Figure-1)
1) Peel off the DADF Platen Cushion.
CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
WARNING
The DADF Platen Cushion is attached with
magic tape.
(Figure-1) j0hn4a03
4.2 Disassembly and Assembly