Xerox WorkCentre Pro 423 Service Manual page 319

4. Remove the Vertical Paper Guide. (Figure-3)
1) Remove the screws (4).
2) Remove the Vertical Paper Guide.
(Figure-3) j0hn4d31
5. Remove the Lower Paper Guide together with
Separator Guide. (Figure-4)
1) Remove the screws (2).
2) Release the projections (4) from the Frame and
remove the Lower Paper Guide.
(Figure-4) j0hn4d32
WorkCentre Pro 432/428
6. Remove the Separator Guide. (Figure-5)
1) Remove the spring.
2) Remove the Separator Guide.
(Figure-5) j0hn4d33
Installation
Procedure
1. Perform the removal steps in reverse order.
03/02
4-45 CHAPTER 4 DISASSEMBLY/ASSEMBLY AND ADJUSTMENT
REP 13.16.1 Finisher Control PWB
Ref. PL PL13.16
Removal
On printer or Fax-equipped machines, ensure that
outstanding jobs have cleared before servicing or
interrupting the power to the machine as follows:.
• FAX equipped machines: Ensure that the "Job in
Memory" indicator on the control panel goes out.
Press "Job Status:Stop" button and confirm that the
job has cleared from the "Current Jobs" folder.
• Printer machines: Ensure that "Ready to print or
fax" is indicated on the printer control panel.
WARNING
Switch off the machine and disconnect the
power cord.
CAUTION
Be careful not to damage parts by static electricity.
Electronic parts may be damaged by static electricity. Be
sure to wear a wristband when handling electronic parts. If
no wristband is available, touch the metal frame before work
to eliminate static electricity as far as possible.
Procedure
1. Remove the Rear Cover. (PL13.17)
4.2 Disassembly and Assembly