Setting Up Interfaces And Cables; Figure C-29. Releasing The Bottom Pulley Assembly; Figure C-30. Removing The Bottom Pulley Assembly - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

C-28 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
5. Remove the screws on both sides of the bottom pulley assembly (

Figure C-29. Releasing the bottom pulley assembly

6. Slide the bottom pulley assembly
1

Figure C-30. Removing the bottom pulley assembly

Setting up Interfaces and Cables

The following sections describe the cables required for each of the connectors at the rear panel
(see Figure C-31).
See section "Cabling the PTM and Multi-Unit Library System" for detailed information on how
to connect cables to the PTM motor housing assembly and Library units.
1
cc0048
out of the PTM extrusion


2
Figure C-29).


(see Figure C-30).

cc0049