Figure C-12. Securing The Ptm To The Slave Unit - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

C-14 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
8. Align the two holes on the extrusion with mounting holes on the slave unit and attach the
PTM in place using two bullet-nose thumbscrews and washers (
fully tighten the thumbscrews at this time.

Figure C-12. Securing the PTM to the slave unit

NOTE: If a screw hole is offset, push the slave unit slightly forward to make a gap between it and the
channel. This lets you start threading the thumbscrews into the slave unit.
9. Repeat Steps 7 through 9 for each additional slave unit. Do not fully tighten the
thumbscrews at this time.
10. Tighten all rear storage cabinet slide screws.
11. Tighten all PTM thumbscrews.
12. Tighten all screws that secure the Library unit's mounting ears to the front of the storage
cabinet.
13. Attach all power and communication cables. See "Cabling the PTM and Multi-Unit
Library System," described later in this appendix.
Figure C-12). Do not


1
cc0031