Library Options; Bar Code Options - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

Library Options

Configuration: Configuration: Lets you configure the Library as a standalone, master, or slave unit. The default Configuration: Configuration:
is standalone.
Unload Mode: Lets you determine whether a SCSI MOVE MEDIUM command is interpreted as Unload Mode: Unload Mode: Unload Mode:
Implicit or Explicit . If Implicit, the unit unloads a drive before attempting to move a cartridge
from that drive. If Explicit, the host must issue a SCSI UNLOAD command to a drive before
each MOVE MEDIUM command that removes a cartridge from that drive. The default is
Implicit.
Numbering: Lets you specify whether SCSI elements in the unit display with either zero or one. Numbering:
Numbering: Numbering:
This affects only the front panel display, not the actual SCSI element addresses. The default is 0.
Auto Clean: Auto Clean: Lets you enable an automatic cleaning cycle which operates as part of the cartridge Auto Clean: Auto Clean:
unload sequence whenever the Use Cleaner LED lights. To use this option, you must have
reserved a slot for a cleaning cartridge using the Reserve Slots option. The default is Disabled.
Library Mode: Lets you set the robotics operating mode to Random, Sequential 1, Sequential 2 Library Mode: Library Mode: Library Mode:
or Sequential Split. The default is Random.
NOTE: The sequential operating modes are available in standalone configuration only. If only one drive is
installed, only the Sequential 1 option is available.
Random —Normal operating mode. Enables complete host control of the robotics.
Sequential 0 —Loads cartridges in numerical order in all 19 magazine slots for Drive 0.
Sequential 1 — Loads cartridges in numerical order in all 19 magazine slots for Drive 1.
Sequential Split —Loads cartridges in numerical order in magazine slots 0 through 9 for
Drive 0 and magazine slots 10 through 18 for Drive 1.
Baud Rate: Lets you set the data transmission rate of the trace port. This function is intended for Baud Rate:
Baud Rate: Baud Rate:
use by CEs only. The default is 38400 bits/s.
Reserved Slots: Lets you withdraw from use a specified number of slots in the back of the Reserved Slots:
Reserved Slots: Reserved Slots:
magazine. Some host software imposes size limits on tape library magazines for licensing
purposes, and does not operate with a library that exceeds the licensed size. The default is 0.
Model Number: Lets you change the model number information displayed on the initial screens. Model Number:
Model Number: Model Number:
You can choose between Compaq SSL2020, a blank line, and a vendor unique number. The
Default is Compaq SSL2020.

Bar Code Options

Label Size: Lets you limit length of the bar code label. Possible settings are 1 through 8. The Label Size:
Label Size: Label Size:
default is 8.
Label Alignment: Lets you specify the alignment of a bar code label. The options are Left or Label Alignment:
Label Alignment: Label Alignment:
Right. When used in conjunction with the label size option, strips unwanted trailing characters
(left alignment) or leading characters (right alignment). The default is Left Alignment.
Check Digit: Check Digit: Lets you set the data transmission rate of the trace port. This function is intended Check Digit: Check Digit:
for use by CEs only. The default is Enable/No Send.
Installation C-43