Removing And Replacing The Controller Board; Figure 5-4. Jack Screw Locations - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

5-6 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
To replace the bar code reader:
1. Slide the new bar code reader on the shuttle assembly.
2. Tighten the two screws that secure it to the assembly (see Figure 5-3).
3. Reconnect the bar code reader cable (see Figure 5-2).

Removing and Replacing the Controller Board

To remove the controller board:
1. Remove the power supply as described later in this chapter.
2. Disconnect the following from the controller board:
a. Operating panel harness (J4)
b. Front door opto cable (J9)
c. Front door solenoid cable (J11)
d. Magazine opto cable (J12)
e. Magazine solenoid cable (J14)
f. Serial cables for drive 0 (J7) and drive 1 (J6)
g. SCSI cable.
3. Remove the four jack screws (see Figure 5-4):
a. Two for the motor connector
b. Two for the diagnostic connector.

Figure 5-4. Jack screw locations

Jack Screw
Locations
0
1
cc0075