Figure C-17. Attaching Tie Bars To The Ptm Extension - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

C-18 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
7. Attach the tie bars to the PTM extrusions using four screws (two each side).
See Figure C-17.
8. Move location stop pin to lowest PTM extrusion (

Figure C-17. Attaching tie bars to the PTM extension

Installing a New Belt
1. Obtain a belt from extension kit and then cut it to the appropriate length (see Figure C-18).
NOTE: A new full-length belt is marked 2, 3, 4, and so forth indicating where to cut per number of
Library units the PTM will service.
Figure C-14).


cc0036