Connecting To The Physical Sp From A Laptop; Interfaces For The Hpe 3Par Sp - HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual

Connecting to the physical SP from a laptop

Procedure
1. Connect an Ethernet cable between the physical SP Service port (Eth1) and a laptop Ethernet port.
Figure 25: Connecting an Ethernet cable to the physical SP Service port
2. Temporarily configure the LAN connection of the laptop as follows:
a. IP Address: 10.255.155.49
b. Subnet mask: 255.255.255.248
3. Log in to the HPE 3PAR SP software. In a browser window, enter: https://
10.255.155.54:8443/.

Interfaces for the HPE 3PAR SP

Interfaces with HPE 3PAR SP 5.x:
IMPORTANT:
HPE 3PAR SP 5.x requires HPE 3PAR OS 3.3.1 and later versions.
• HPE 3PAR Service Console (SC) interface: The HPE 3PAR SC interface is accessed when you log
in to the HPE 3PAR SP. This interface collects data from the managed HPE 3PAR StoreServ Storage
system in predefined intervals as well as an on-demand basis. The data is sent to HPE 3PAR Remote
Support, if configured. The HPE 3PAR SC also allows service functions to be performed by a company
administrator, Hewlett Packard Enterprise Support, or an authorized service provider. The HPE 3PAR
SC replaces the HPE 3PAR Service Processor Onsite Customer Care (SPOCC) interface and the
HPE 3PAR SC functionality is similar to HPE 3PAR SPOCC.
• HPE 3PAR Text-based User Interface (TUI): The HPE 3PAR TUI is a utility on an SP running SP 5.x
software. The HPE 3PAR TUI enables limited configuration and management of the HPE 3PAR SP
and access to the HPE 3PAR CLI for the attached storage system. The intent of the HPE 3PAR TUI is
not to duplicate the functionality of the HPE 3PAR SC GUI, but to allow a way to fix problems that may
prevent you from using the HPE 3PAR SC GUI. The HPE 3PAR TUI appears the first time you log in to
the Linux console through a terminal emulator using Secure Shell (SSH). Prior to the HPE 3PAR SP
initialization, you can log in to the HPE 3PAR TUI with the admin user name and no password. To
access the HPE 3PAR TUI after the HPE 3PAR SP has been initialized, log in to the console with the
admin, hpepartner, or hpesupport accounts and credentials set during the initialization.
56 Connecting to the physical SP from a laptop