HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual page 137

C-36 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
4. To select a configuration option, press the p or q button on the control panel until the u
appears next to the option you want to change. The first two choices on this menu, SCSI
Options and Library Options, are actually categories of options. In this case, choose SCSI
Options. Press the Enter
submenu appears:
u Library Parity:
*Enabled
Library Bus ID:
*0
NOTE: Look closely at the submenu listed above and note that the u on the display is next to line 1, and
that line 2 is indented. This tells you that it is a two-tiered menu. The p and q buttons work on two
levels in this kind of menu, which is typical of many submenus of the Configure menu. The first level is
as follows: If you press the q button, the u moves to line 3. If you press the p button, the u moves
back to line 1.
If you press the Enter
operate on the second level. As a result, the u moves next to line 2 (or line 4), and a ¤ appears
at the end of line 4, indicating that there is a list of settings that can be selected using the p and
q buttons.
The ¤ at the end of line 4 means that there are other options that can be displayed by scrolling,
using the q button repeatedly.
5. For example, set the Drive 0 bus ID to 3. With the u next to line 1, press the q button
until the display scrolls as shown:
u Library Bus ID:
*0
Drive 0 Bus ID:
*4
6. With the u next to line 3, press the Enter
at the end of line 4, and a £ displays at the end of
line 1.
7. Use the p and q buttons to scroll line 4 to display the possible settings. Scroll up so that
a 3 appears and then press the Enter
left of the 3 indicating it is the current selection.
8. Press the Escape
9. Repeat this procedure for each configuration option you want to change.
Enter button to display the options for that category. The following Enter Enter
¤
Enter button while the u is next to line 1 (or line 3), the p and q buttons
Enter Enter
£
¤
Enter button to save the new selection. An
Enter Enter
Escape button repeatedly until the submenu reappears. Escape Escape
Enter button. The u moves to line 4, the ¤ remains
Enter Enter
*
appears to the