Map Information Screen; Using The Menu Mode - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

Map Information Screen

When you select Map Info, the following screen appears. The location being reported appears
on Line 1. The content of the bar code on the label, up to 6 characters, appears on Line 4.
Drv 0
Occupied
Label Valid
XXXXXXXX
The list of locations available for display on line 1 is as follows. If you do not designate any
mail slots, those lines are omitted from the list.
Drive0
Drive1
Slot0
Slot1
. . .
Slot18
Mail Slot
Depending on the report for each location, Line 2 might display either Empty or Occupied, or, if
a magazine is absent, Not Installed. Depending on the report for each location, Line 3 might
display either Label Valid, or Label Not Present.
For each location reported, Line 4 displays the actual bar code on the label, up to 6 characters.

Using the Menu Mode

NOTE: When the Library enters the Menu mode, the Ready LED goes out. This means that the module is
offline, and responds to all commands from the host with a SCSI Not Ready until you exit the Menu Mode
and the Ready LED comes on.
To prevent interruption of host operations, you can lock out the Menu Mode using the Security
menu. See "Security Menu" later in this chapter. When all control panels are locked, you must
enter your unlock code to display the Main menu.
When the Default screen appears, you can enter the Menu Mode by pressing the Enter
The following Main menu appears:
u
Load/Unload
Remove Magazine
Maintenance Menu
Configure Menu
NOTE: If the control panel has been locked, the following screen appears instead of the one shown
above. You must know the unlock code for the Library before you can continue.
Front Panel Locked
ENTER to Unlock
ESCAPE to Exit
¤
¤
Operation 2-11
Enter button. Enter Enter