Removing The Cleaning Cartridge; Exercising The Library Robotics - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

6. The following Cleaning Confirmation screen appears:
Cleaning:
Using:
ENTER To Execute
ESCAPE To Cancel
7. As the Cleaning Confirmation screen indicates, to execute the cleaning operation, press
the Enter Enter button. If the Cleaning Confirmation screen does not show your intended drive
Enter Enter
and cleaning cartridge, press the Escape
When you press the Enter
Cleaning:
Using:
Cleaning In Progress
When the cleaning operation completes, the Default screen reappears.

Removing the Cleaning Cartridge

1. Examine the Default screen on the control panel to make sure the cleaning cartridge has
been unloaded from the drive. If not, then unload it using the Load/Unload menu, as
described in Chapter 2, "Operation . "
2. Remove the magazine from the Library. See "Inserting and Removing Cartridges" in
Chapter 2.
3. Remove the cleaning cartridge from the magazine.
4. Insert any desired data cartridge into the slot vacated by the cleaning cartridge.
5. Insert the magazine into the Library.
6. Close the magazine door.

Exercising the Library Robotics

To fully exercise the library robotics, use the Demo option as follows:
1. From the Maintenance menu, select the Demo submenu.
2. Select Demo 1.
The library robotics begin to move cartridges randomly from slot to slot, displaying the number
of passes on the screen.
If all slots in the magazine are full, Demo 1 loads a cartridge into DLT0 and leaves it there. If
you press the F button while Demo 1 is running, the Library loads a cartridge into DLT0,
unless DLT0 is full. If you press the F button again, the cartridge is unloaded from DLT0 and
returned to the magazine.
Demo 1 runs continuously as long as the Library has power.
To pause Demo 1, press and hold the Escape
test is paused.
To stop Demo 1, press the Escape
Drive 0
Slot 0
Escape button to return to the Cleaning submenu. Escape Escape
Enter button, the following Cleaning In Progress screen appears: Enter Enter
Drive 0
Slot 0
Escape button until a flashing message displays that the Escape Escape
Escape button a second time to return to the Main menu. Escape Escape
Maintenance 3-3