C-20 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
NOTE: The belt included with your kit accommodates up to four PTM extrusions. The belt is marked at
numbered intervals, indicating the exact length needed for your Library system.
2. Thread the belt through the bottom pulley. Note the orientation of the belt teeth and the
location stop pin (
3. Thread the belt through the top pulley.
Figure C-19. Threading the belt through the pulleys
Number of
Extrusions
2
3
4
Figure C-19).
Length of Belt
27 inches
41 inches
55 inches
1
cc0038