Removing And Replacing The Power Supply Assembly; Figure 5-22. Magazine Latch Solenoid Mounting Bracket Screw Locations - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

5-20 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
4. Remove the two screws that secure the magazine latch solenoid to its mounting bracket
(see Figure 5-22).

Figure 5-22. Magazine latch solenoid mounting bracket screw locations

5. Push the detached solenoid back through the opening into the power supply compartment.
6. Disconnect the cable at connector J14 on the controller board, and then remove the
magazine latch solenoid.
To replace the magazine latch solenoid:
1. Position the magazine latch solenoid through the opening in the Library chassis toward the
magazine compartment.
2. Tighten the two screws that attach the solenoid to its mounting bracket (see Figure 5-22).
3. Replace the magazine latch cover (see Figure 5-21).
4. Connect the cable at connector J14 on the controller board.
Removing and Replacing the Power Supply
Assembly
To remove the power supply:
1. Turn off the Library.
2. Unplug the Library from the power source.
3. Remove the Library outside cover. If necessary, see Figure C-4 or Figure C-5.
4. Remove the brace plate cover (see Figure 5-10).
Magazine Latch Solenoid
Mounting Screws
cc0092