Table of Contents
Advertisement
3-2 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
Running a Cleaning Cartridge Automatically
You can configure the Library so that it runs the cleaning cartridge automatically. Because the
cleaning cartridge is abrasive, you should not use it unless Use Cleaner appears on the control
panel screen. The completion of an unload operation on a drive that needs cleaning causes the
Use Cleaner LED to light. This in turn activates an automatic cleaning cycle if Auto Clean has
be selected from the Configuration menu.
To run a cleaning cartridge automatically using Auto Clean:
1. Reserve a slot as the cleaning slot:
See "Setting Up Reserved Slots" in Appendix C.
If you have more than one reserved slot, the Cleaning Slot is the first reserved slot.
Reserved slots are at the back of the magazine.
2. Install a cleaning cartridge into Reserved Slot #1.
3. Enable the Auto Clean option on the Configuration menu:
From the Main menu, select Library Options / Auto Clean / Enabled.
Running a Cleaning Cartridge Manually
1. Install the cleaning cartridge into any slot. (Slot 0, for example.)
2. At the Default screen, press the Enter
u Load/Unload
Remove Magazine
Maintenance Menu
Configure Menu
3. Scroll down to the Maintenance menu and press the Enter
Maintenance submenu appears:
u Clean Drive
Diagnostic menu
Demo Menu
Flash Update
Press the Enter
4.
appears:
Cleaning:
u *Drv 0
Using:
*Slot 0
5. Press the Enter
available on Line 4 are slots 0 through 18. Press the Enter
in Slot 0.
NOTE: If you cannot use slot 1 for the cleaning cartridge, you can scroll line 4 to select another slot.
Enter button. The following Main menu screen appears:
Enter
Enter
¤
¤
Enter button once to select Clean Drive. The following Cleaning submenu
Enter
Enter
Enter button to accept Drive0. The K moves to line 4 of the display. The choices
Enter
Enter
Enter button. The following
Enter
Enter
Enter button again to use the cartridge
Enter
Enter
Advertisement
Table of Contents
Troubleshooting
